02-27-2020, 03:38 PM
Hey guys,
yesterday i plugged in and configured a wired Xbox360 controller. Since then, the xbox gamepad is configured to port #1, even if it's not connected! So with the built in Retrostone Controller i can navigate and start a game, but in the game i can't use it because of the wrong controller order (port #2 , see in picture) . I tried alot a few hours and downloaded a RetroPie joystick selection master, but i couldn't figure out where/how to install it. What is the best way to switch the order? Can somebody help?
yesterday i plugged in and configured a wired Xbox360 controller. Since then, the xbox gamepad is configured to port #1, even if it's not connected! So with the built in Retrostone Controller i can navigate and start a game, but in the game i can't use it because of the wrong controller order (port #2 , see in picture) . I tried alot a few hours and downloaded a RetroPie joystick selection master, but i couldn't figure out where/how to install it. What is the best way to switch the order? Can somebody help?
